Mining
Block caving is the most commonly used method in excavating diamonds from kimberlite deposits. This method offers the highest yield and thus is the most cost effective. First, a large vertical hole is excavated, typically 1,750 feet (533 m) in diameter. Levels are placed approximately every 40 feet (12 m). Along these levels are horizontal tunnels known as scraper drifts. In the drifts, there are small inclined coneshaped openings at intervals of every 11 feet (3 m) or so. These openings are roughly four feet by four feet. When a horizontal slice is cut above the cones—usually about six feet (1.8 m) in height—the kimberlite begins to break off and fall into the cone and into the scraper drift. The material is then pushed onto trucks. The trucks travel underground through the mining area and take the collected kimberlite to a crushing device.
No comments:
Post a Comment